LaserLiner MasterCross-Laser 2GP Manual Del Usuario página 9

1
1 Laser emitting window
2 Slide switch
a ON
b Slope mode
c OFF / Transport lock
3 Battery compartment
(bottom)
Horizontal and vertical levelling
2
Release the transport restraint, set slide switch (2) to "ON". The laser cross, the plumb laser and
the reference beam appear. The lasers can be switched individually using the selection button.
LASER LASER
The transport restraint must be released for horizontal and vertical levelling. The selected lasers
!
flash when the device is outside the automatic levelling range of 3°. Position the device such
that it is within the levelling range. The selected lasers shine continuously.
MasterCross-Laser 2GP
a b c
3
4
5
10
4 5/8" tripod threads
(bottom)
5 1/4" tripod threads
(bottom)
6
Hand receiver mode
7 LED Hand receiver mode
LASER LASER
11
7
6
2
When transporting always
!
switch off all lasers, secure
the pendulum and set the
slide switch to "OFF"!
8 LED Status indicator
9 Laser line selection button
10 Laser emitting window,
plumb laser
11 Laser emitting window,
reference beam
8
9
09
EN