Introduction Thank you for purchasing the Ubiquiti Networks® NanoStation® 5AC loco. This Quick Start Guide is designed to guide you through the installation and also includes warranty terms. Package Contents 5 GHz airMAX ® AC Radio Model: Loco5AC NanoStation Zip Tie...
Installation Requirements • Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial‑grade, shielded Ethernet cable from Ubiquiti Networks.
Port View Power Ethernet Reset Port Button Power LED The Power LED will light blue when the device is connected to a power source. Ethernet Port 10/100/1000 Ethernet port used to connect the power and should be connected to the LAN and DHCP server. Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the NanoStation...
Hardware Installation 1. Remove the port cover by pressing down on the center of the cover and sliding the cover out. 2. Connect an Ethernet cable to the Ethernet Port. 3. Replace the port cover.
Página 7
Pole Mount 1. Position the NanoStation loco at the desired location on a pole and insert a Zip Tie into the slot of the Mounting Bracket.
Página 8
2. Align the front of the NanoStation loco toward the other end of the wireless link. Then tighten the Zip Tie around the pole. 3. Connect the Ethernet cable from the NanoStation loco’s Ethernet port to a PoE‑enabled Ethernet port on a switch. WARNING: The switch port must comply with the power specifications listed in the Specifications...
Accessing airOS via Wi‑Fi Verify connectivity in the airOS® Configuration Interface. There are two methods, the UNMS app and Web Portal. Both ™ are available for 15 minutes immediately after you power on the NanoStation loco. If necessary, you can power cycle the NanoStation loco to re‑enable its Wi‑Fi.
Página 10
5. Tap Connect on the Login screen. 8 : 08 100 % Login Connect Name NanoStation 5AC loco CONNECTION Address 192.168.172.1 Port Require HTTPS CREDENTIALS Username ubnt Password NS-5ACL:F09FC12EXXXX 6. Select your Country and tap Done. 8 : 08 100 % Select Country Cancel Done...
Página 11
Web Portal 1. Connect your device’s Wi‑Fi to the NanoStation loco SSID named: Loco5AC:<MAC Address> Note: Ensure that your Wi‑Fi connection has DHCP enabled. 2. Launch a web browser and go to: http://setup.ubnt.com http://setup.ubnt.com 3. Select your Country and Language. You must agree to the Terms of Use to use the product.
Página 12
Installer Compliance Responsibility Devices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements. The Output Power field is provided to the professional installer to assist in meeting regulatory requirements.
Página 13
Specifications Loco5AC Dimensions 179 x 77.5 x 59.1 mm (7.05 x 3.05 x 2.33") Weight 180 g (6.35 oz) Processor MIPS 74K Memory DDR2 64 MB Antenna Gain 13 dBi Networking Interface (1) 10/100/1000 Ethernet Port Power Method Passive PoE 2‑Pair (Pairs 4, 5+; 7, 8 Return) Power Supply 24V, 0.3A Gigabit PoE Supply* Max.
Safety Notices Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in a location that can be submerged by water. WARNING: Avoid using this product during an electrical storm.
Página 15
Compliance Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
Página 16
RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 25 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilisées pour ce transmetteur doivent être installé...
Página 17
RoHS/WEEE Compliance Statement English European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Página 18
Español La Directiva 2012/19/UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Íslenska [Icelandic] Hér með lýsir UBIQUITI NETWORKS yfir því að Loco5AC er í samræmi við grunnkröfur og aðrar kröfur, sem gerðar eru í tilskipun 2014/53/EU. Fullur texti ESB samræmisyfirlýsing er að finna á eftirfarandi netfangi: www.ubnt.com/compliance...
Malti [Maltese] B’dan, UBIQUITI NETWORKS, niddikjara li dan it‑tip ta’ tagħmir tar‑radju Loco5AC huwa konformi mad‑Direttiva 2014/53/UE. Id‑dikjarazzjoni tal‑konformità tista’ tiġi kkonsultata minn www.ubnt.com/compliance Norsk [Norwegian] UBIQUITI NETWORKS erklærer herved at utstyret Loco5AC er i samsvar med de grunnleggende krav og øvrige relevante krav i direktiv 2014/53/EU. Den fulle teksten til EU‑samsvarserklæringen er tilgjengelig på...