• Do not swi t ch on the devi c e when there i s no water i n the Reservoi r .
• Do not use metal or hard obj e ct to cl e an the Osci l l a tor.
• Do not use any harsh chemi c al s i n the water Reservoi r .
• Do not put the devi c e i n to water, or l e t water get i n to the Mai n Base.
• To avoi d damages due to escapi n g water, the uni t may not be pl a ced on
the fl o or.
• Do not touch the Osci l l a tor duri n g operati o n.
• Never submerge the uni t wi t h el e ctri c al system and ai r vent i n water or
other l i q ui d s or ri n se i t off wi t h water or other l i q ui d s.
• Do not use the devi c e i n an area where the humi d i t y l e vel exceeds 60
percent.
Never tilt, move, or attempt to empty the device while it is operating.
FIRST USE / OPERATION
Preparation:
When using your Atlas for the first time, place it on a smooth, flat and stable surface. To stabilize it,
you can fold out the 2 Feet (4) stalled under the Main Base (3).
Pull out the fixation on the Adapter (8) by pressing the button on the Adapter. Select the suitable Plug
(9) and (10), and install it by pushing back into the slot with a "click" sound.
Fill a bottle with max 0.5 liter (22 oz) clean, fresh and cold water and fix the Bottle Adapter (5) onto
the bottle completely till it stops. Do not use carbonated water. To avoid scales, distilled water is
recommended.
Operation:
1. Open the Mist Outlet (1), and make sure it is not facing directly or too close to electrical sockets,
walls and other objects.
2. Push the bottle, together with the Bottle Adapter (5) back onto the Main base (3). Do not press
the plastic bottle.
3. Plug in the Adapter into the Socket (7) and with the Plug (9) or (10) into the main power supply.
4. Switch on the unit by turning the Main Switch (6) clockwise.
5. Mist output can be adjusted by turning the Main Switch (MAX is on the very right end of the dial)
6. When there is not enough water in the unit, the unit will be switched off, and bottle must be
refilled with fresh clear water.
15