Troubleshooting - Coplax stylies ATLAS Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
Important Notes:
Do not refill Altas without first disconnecting from the main supply.
CLEANING PROCEDURE
Your Travel Humidifier is a reliable and robust product, its good performance however require regu-
lar maintenance. The frequency of maintenance depends on how and how often you use it.
Depending on the water hardness, you may find calcium and magnesium scales or other contamina-
tions left in the Reservoir covering the surface of the Oscillator. therefore , you need to clean and to
descale your Atlas regularly, depending on the operating time.
To avoid lime scales
• Use clean and softened water, cold boiled water, or distilled water.
• Clean the Reservoir, especially the surface of the Oscillator weekly: do NOT use any sharp tool
or instruments.
• Dry the unit completely with clean soft cloth after your use and before storage.
Descaling and Cleaning
• Switch off the unit by turning the Main Switch (6) to the very left side of the dial and disconnect
the Adaptor from main supply.
• Clean the bottle, the Bottle Adapter, Mist Outlet. Remove scales and residual dirt by de-calci-
fication agent.
• The surface of Oscilliator can be cleaned with the Brush (12).
• Note: this product is NOT dishwasher save
• Rinse all the parts with fresh clean water. Note: be careful not to let water running into the
Base Unit.
• Dry all parts with soft cloth.
IMPORTANT:
Do not use cleaning agents or other scouring agents to clean the unit.
Do not use any metal or hard objects to clean the Oscillator.
TROUBLE-SHOOTING
Problem
Unit switched on, but no
mist coming out
Unit gives only small
amount of mist coming
from the unit
Unit gives bad smell
Possible Cause
Adaptor not properly con-
nected with the unit and
the main supply
Too much scale or water
level is too high
Reservoir is dirty or not
properly cleaned
Solution
Check if the Adaptors Plug
is properly inserted into
main supply socket and
with the Adaptor socket on
the Main Base
Clean the unit and remove
the scale, or take out some
water from Reservoir
Clean the unit, and refill
with fresh water
16

Publicidad

Tabla de contenido
loading

Tabla de contenido