Kenmore 116.36720 Manual Del Propietário página 15

kWARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the vacuum
cleaner. Failure to do so could result
in electrical shock or personal injury
from vacuum cleaner suddenly start-
ing.
Frequently check and remove hair, string
and lint build-up in the brush area. If build-
up becomes excessive, follow the steps
below. Should the belt become loose or
should it break, follow the Be_t Removal
Instructions.
TO REMOVE NOZZLE COVER
Disconnect electrical supply.
To protect the floor surface, always place
paper under the nozzle any time the nozzle
cover is removed.
Release the nozzle cover by rotating the
nozzle cover retainers to the UNLOCK
position. Grasp back of nozzle on each side
and lift up to remove it from nozzle cover.
....-11
Nozzle
Cover
Carefully remove any residue that may exist
in the belt area.
IbWARNING
Personal Injury Hazard
Always unplug the vacuum cleaner
before cleaning the brush area as
agitator may suddenly restart.
Failure to do so can result in person-
al injury.
TO REMOVE BELT/CLEAN
AG ITATOR
Belt
Position hands on the agitator. If the belt is
still attached to the agitator, there will be
tension on it.
Carefully tilt the right end of the agitator and
then lift the left end.
Remove the worn or broken belt from the
motor drive shaft.
, WARNING
Personal Injury Hazard
Be careful when removing the agita-
tor as the belt tension is high, Failure
to do so could result in personal
injury from the agitator releasing
quickly and snapping away.
15