Cleaning Nozzles; Cleaning Water Filter; Storage - NORSE PROFESSIONAL SK25i Operación Manual

English
SK25i

Cleaning Nozzles

A clogged or partially clogged nozzle can cause significant reduction of water pressure coming out of the
nozzle and/or cause the unit to pulsate while spraying. Turn off the power and water supply to the power
washer. Relieve any pressure trapped in the hose by squeezing the trigger 2 - 3 times, then lock the gun
by pressing the button to lock position.
Using the nozzle tip cleaner provided (or an unfolded paper clip),
11
insert the wire into the nozzle hole and move back and forth until
debris is dislodged. Back flush water through the nozzles using
garden hose and highest pressure available (either standard water
nozzle or use your thumb over the nozzle to create water pressure
for back flush).

Cleaning Water Filter

Dismantle the water filter (10) by twisting the quick connector off
the filter end. Rinse with clean water and reassemble.
10

Storage

When your cleaning session has been completed, turn off the water
supply. Pull the trigger on the spray gun for 2-3 seconds to drain
out the excess water and to release any remaining water pressure.
Do not allow the power washer to run with no water flowing
through it. Remove lance from the gun. Make sure to discard any
remaining detergent from the tank. Residual chemical will stick to
the container which could become contaminated, and can cause
the detergent injector to clog and not function properly. Flush the
tank and nozzle head with clear water to prevent clogging. Remove
the battery pack. DO NOT store the power washer where it is
exposed to freezing temperatures. Store the power washer indoors
to prevent the water in the unit from expanding under freezing
conditions. When the water freezes and expands, your power washer will be damaged and become
inoperable.
© NØRSE 7