Nogueira Tn-10 Manual De Instrucciones página 20

Cardan shaft length adjustment:
Follow the instructions:
A) Uncouple the cardan (1).
B) Remove the cardan shield according to
instructions in the previous page.
C) Couple the machine to the tractor.
For the procedures below, the tractor
should be off and without the start
key.
D) Disassemble the cardan, hitch the tuve (2) to the
tractor's PTO and the bar (3) to the machine.
E) Join the parts of the cardan side by side
(according to side picture) and check whether there
is a minimum gap of 3 cm on each end.
If the play is smaller than the mentioned one or
there is no play at all, mark and cut the tube (2) and
the bar (3) of the cardan, as well as the protecting
tube (4), all in the same proportion (measurement).
F) With a file, remove the saw burrs resulting from
the cuts. Please, use gloves and goggles to protect
your hands and eyes.
G) Apply grease in the internal end of the tube and
on the cardan's bar.
H) Assemble all the cardan shaft components
according to the instructions in the previous page
and couple it again.
20
Operation Technical Manual
2
Tractor
3 cm
1
4
3 cm
Chopper
3