Additional Functions; Troubleshooting Guide; After Each Use - Guardian Technologies SPA101 Instrucciones De Uso Y Cuidado

ADDITIONAL FUNCTIONS

1. Use the Power Button to turn the LED night light ON/OFF.
Press once: Diffuser ON/Night Light OFF
Press twice: Diffuser ON/Night Light ON
Press three times: Diffuser OFF/Night Light OFF
2. Auto Shut Off: When the unit water level is too low, it will automatically shut off.

AFTER EACH USE

1. Turn the device OFF and unplug the unit from the electrical outlet. Lift off the top cover
and the inner water tank cover.
2. Drain and rinse the water tank thoroughly to remove any sediment and dirt. Wipe clean
and dry with a clean soft cloth or paper towel.
3. Remove water and clean the water tank after each use. If oil residue or the previous scent
remains in the tank, then deep clean by adding a mixture of 1 tsp. white vinegar and 1 tsp.
water. Let solution stand for 5 minutes. Clean with a soft brush, empty and rinse
thoroughly with water.
IMPORTANT: Do NOT fill with HOT water as this may cause leaking. Remove the water from
the tank when the diffuser is not in use.
NOTE: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR
HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE
TO THE DIFFUSER OR PERSONAL INJURY.
E-6

TROUBLESHOOTING GUIDE

PROBLEM
Water vapor not produced.
Air blows, but water vapor is not
produced.
The diffuser mist has a bad smell.
Unit has stopped working.
Water is accumulating outside of unit or
area surrounding unit.
Increased noise level.
Water vapor, but no scent.
Aromatherapy essential oils can be purchased at
www.guardiantechnologies.com
SOLUTION
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try
again.
Excessive Water: Remove a certain amount of
water from the tank.
Poor maintenance of dirty water: Clean the product
thoroughly, and fill it with fresh water.
No or low water. Unplug unit and refill tank.
Unit not level and water is accumulating. Unplug
and place on level surface. Raise unit on a water-
resistant level surface 2-3 feet off of floor.
Unit must be placed on a flat, level, hard surface,
Make sure it is NOT placed on a soft absorbent
surface.
Add more drops of oil mid-cycle.
E-7