Assembly Procedures - EAS ELECTRIC EPUR660 Manual De Instrucciones

Assembly Instructions

Assembly procedures

1
Take down the air inlet grill
5
Assemble the HEPA filter
2
Take out the Pre-Filter
Press the U-shaped buckle
to pull outward, and take out
the Pre-Filter
6
Assemble the Pre-Filter
Align the slot position at the
bottom, and buckle up the upper
U-shaped buckle
3
Take out the HEPA filter
Hold both sides of the HEPA filter
with both hands, and take out the
HEPA filter
7
Assemble the air inlet grill
Align the slot position at the
bottom, press both sides of the
upper part of the air inlet grill, and
buckle up the air inlet grill
4
4
Remove the protective film of
the filter
8
Assemble the filter on the
other side
Repeat Steps 1-7 to assemble the
filter on the other side, and then
power on for operation
V.2