Kohler K-1158-G Guia De Instalacion página 2

No change in measurements if connected with
drain illustrated. (K-7161-AF or K-7161M-AF)
41-3/4" (106 cm)
2"
(5.1 cm)
Product Information
Applicable product:
Drop-in bath
Drop-in bath with chromatherapy
Fixture*:
Bathing well:
Basin area, bottom
Basin area, top
Weight
To overflow:
Water depth
Capacity
* Approximate measurements for comparison only.
Blower Heater
motor/
300 W
control:
Included component:
Cut-out template
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Blower motor/control:
1043960-1-D
Blower/Control Access
34" (86.4 cm) W x 15"
(38.1 cm) H Max
22"
(55.9 cm)
K-1158-G
K-1158-GCR
46" (116.8 cm) x 30" (76.2 cm)
57" (144.8 cm) x 34" (86.4 cm)
130 lbs (59 kg)
16" (40.6 cm)
95 gal (359.6 L)
V Hz
220-240 V 50/60
1043292-7
220-240 V, 15 A, 50/60 Hz
Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are relocated, the
following two procedures are required: 1. Provide two access
panels. Locate one access panel at the blower motor/control
location and the other access panel at the control box. 2. Relocate
the blower motor and the check valve together. Do not relocate one
without the other.
Floor support under bath must provide for a minimum of 50
lbs/square foot (242 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
This bath is designed for drop-in installation only. It is not suited
for use in a three-wall alcove with an overhead shower.
A blower motor/control access panel is required.
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.2.
A
3
2
11-1/4" (28.6 cm)
65-7/8" (167.3 cm)
1" (2.5 cm)
2-7/8"
(7.3 cm)
20-7/8"
(53 cm)
2-1/4"
(5.7 cm)
2-3/4"
(7 cm)
1-1/2" OD
Kohler Co.