Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2
- Decreases the active suction speed
(power) (4→3→2→1→OFF).
The speed is displayed through the
LED related to the corresponding
speed.
Key
2
has no effect on the opening/
closure of the suction panel.
3
- Increases the active suction speed
(power) (1→2→3→4).
The speed is displayed through the
LED related to the corresponding
speed.
Note: suction speed 4 (power) is timed
for 6 minutes, after which the hood will
automatically switch to suction speed 3
(power).
Note: If the panel is closed (hood is
off) key
3
activates the opening of the
suction panel first and then sets the
hood to the suction speed (power) 1.
4
- Switches on the light
Note: If the suction panel is closed
(hood is off) key
opening of the suction panel first and
then switches on the light.
5
- Opens (Lifts) and closes (lowers) the
suction panel.
With the hood switched off and the
panel closed, key
panel first and then sets the hood to the
suction speed (power) 1.
With the hood switched on (at any
speed) and the panel open, key
switches off the hood first (and, if they
are on, it switches off the lights as well)
and then closes the suction panel.
Additional operating information
During the removal of the front panel due
to cleaning and maintenance operations,
all the electronic functions of suction and
movement are locked.
Anti-pinch safety: if an obstacle obstructs
the closure of the Downdraft, the closure is
stopped and the trolley goes up.
4
activates the
5
opens the suction
5
Grease Filter saturation signal.
Every 40 hours of use the hood signals the
need for maintenance of the grease filter.
The signal is by making all the
suction speed LEDs (powers) flash
contemporaneously.
Reset of the grease filter signal
After carrying out the maintenance of the
grease filter, press key
in order to reset the signal.
Note: The signal is not displayed with
hood switched off (OFF), regardless of the
position of the suction panel.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
6. LIGHTING
Warning! Prior to touching the light
bulbs ensure they are cooled down.
To replace the neon proceed as indicated
bellow:
1. Lift the panel (extractible drawer).
2. Disconnect the hood from the
electricity.
3. Remove the screws that secure the top
front and lift it up.
4. Remove the damaged neon and
replace it with one having identical
characteristics (Mod. T5 14W 860).
ENGLISH
7
1
for more than 3"
Publicidad
Tabla de contenido
