Resetting The Unit - Manta CLK001 Manual De Usuario

User's Manual E N
In 12hr mode the PM indicator will light for afternoon hours.
3. Press the ALM-SET button again. The minute will begin to blink. Press the up
or down arrow to reach the desired minute. Press the ALM-SET button again
to exit the single alarm setting mode.
To activate or deactivate the alarms:
Press the ALM-SET button until the alarm time will appears at the meantime
press the up button to activate or deactivate the chosen alarm. If alarm sign is
disappears, the alarm has been deactivated.

RESETTING THE UNIT

In case of malfunction or abnormal display, take out and re-install the
batteries again. All settings will be cleared and reset to their default values.
MAINTENANCE
When handled properly, this unit is engineered to give you years of
satisfactory service. Here are a few product care instructions:
1. Do not immerse the unit in water. If the unit comes in contact with water,
dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with abrasive or corrosive materials. Abrasive cleaning
agents may scratch the plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock, dust, temperature, or
humidity. Such treatment may result in malfunction, a shorter electronic
life span, damaged batteries, or distorted parts.
4. Do not tamper with the unit's internal components. Doing so will terminate
the unit's warranty and may cause damage. The unit contains no user -
serviceable parts.
5. Only use new batteries as specified in this instruction manual.
6. Read this instruction manual thoroughly before operating the unit.
CAUTION
- The content of this manual is subject to change without further
notice.
- Due to printing limitation, the displays shown in this manual may
differ from the actual display.
8