Installation Using The Screw Holes On The Side Of This Product - Pioneer AppRadio Manual Del Usuario

Installation
3 Pull the unit out of the dashboard.
Extraction key
Installation using the screw holes
on the side of this product
1 Fasten the unit to the factory radio-
mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the
bracket, and tighten the screws at three or
four locations on each side. Use either the
truss head screws (5 mm × 8 mm) or flush
surface screws (5 mm × 9 mm), depending
on the shape of the bracket's screw holes.
If the tab interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Truss head screw or
flush surface screw
Be sure to use the
screws supplied
with this product.
Dashboard or console
Engb
Section
03
17