SCS KW9025 CC Manual De Instalacion Y Uso página 16

PROCEDURE FOR REGISTERING A SENSOR
• When switched on, the sensor automatically sends temperature information to the station
• To use several sensors (3 at the most), select channel CH1, CH2, CH3 (D4) son each sensor
before fitting the batteries so that each sensor transmits on different channels. When the batteries
have been fitted, the sensor automatically sends the temperature information.
• Press « TX » (D7) on the outdoor sensor to manually force the temperature to be sent to the station.
The station then emits an audible «beep» if it receives this temperature.
Put the cover back when this procedure is finished.
DISPLAY OF OUTSIDE TEMPERATURE
• Press "Channel" (B3) to see the temperature of the sensor (
is as follows
Temperature
display of the
sensor transmitting
on channel 1
• If no temperature is displayed on a channel (" - - . –» is displayed on the screen), press
and hold the «CHANNEL» (B3) key for about 3 seconds to remove this channel. If a sensor
again transmits on this channel, the channel will be recorded automatically. You send the
signal manually to the station by pressing the «TX» button on the outside sensor.
• A trend arrow displayed on the screen indicates the trend for the outdoor temperature
• means that the outside temperature is rising
• means that the outside temperature is stable
• means that the outside temperature is falling
• Press "°C / °F" (B6) to select the temperature in degrees Celsius or in degrees Fahrenheit.
SCS KW9025 CC + KW9010 notice.indd 16
Fit 2 batteries AAA / LR03 and ensure that they follow the
polarity indications + and - in the battery compartment.
Press B3
Press B3
Temperature
display of the
sensor transmitting
on channel 2
ENGLISH
3 at the most
Press B3
Temperature
display of the
sensor transmitting
on channel 3
4
5
). The sequence
P 16
10/08/2010 08:44:55