Operating Your Bath With Airjets - Kohler K-1167 Guía De Propietario

Air Flow Mode
Activates Mode Selected
Rotate Outer Ring to
Access Desired Mode
Power On/Off
Chromatherapy Specific
Color (if provided)

Operating Your Bath with Airjets

NOTE: If the unit does not function properly, please refer to the "Troubleshooting" section.
Starting the Unit
Close the drain.
Fill the bath to a level at least 2" (51 mm) above the top of the airjets.
Use your hand to test the water temperature for comfort and safety.
Carefully enter the bath basin.
Press the On/Off button on the user keypad.
Observe that the air system starts and air begins to flow to all zones.
Observe that the chromatherapy lights (if provided) also begin operation in the cycling mode.
If desired, adjust the air flow rate using the up or down buttons.
After about 15 seconds, observe that only the last feature selected remains illuminated on the user
keypad.
Selecting Air Flow Modes
Rotate the outer ring to select a desired mode.
Observe that the selected icon is flashing blue.
Press the "OK" button to activate the mode.
Observe that the active mode flashes green and the mode is implemented.
Observe that, after about 15 seconds, the icon stops flashing.
To turn off a mode, rotate the outer ring until the icon is flashing green and then press the "OK"
button again.
The icon will then turn blue, indicating the mode is off.
Stopping the Bath
When ready, press the On/Off button a second time to stop the air system.
Carefully exit the bath.
Open the drain to empty the bath.
Observe that when the bath drains below the level sensors the automatic 2-minute purge cycle
occurs. The air system operates at a low speed to blow any residual water out of the air harness.
1087307-5-F
Zone 1
Zone 2
Zone 3
Surge Mode
Chromatherapy Cycle (if provided)
Purge Mode
6
Increase Flow or Surge
Indicator Bar
Decrease Flow or Surge
Kohler Co.