Parallel Connections; Grounding The Generator - Pulsar PG4500iSR Manual Del Operador

Note: The economy switch must be moved to the "OFF" position when using electrical devices that require a large
starting current, such as an air compressor.

Parallel Connections

Located just above the Ground Terminal, the generator's Parallel Connections enable a user to run two PG4500iSR
generators simultaneously. This feature requires special cables and a parallel kit. When operating generators in parallel,
the rated output is 7.4kVA and the rated output is 61.6A/120VAC. To operate generators in parallel consult a PULSAR
dealer for a PARALLEL OPERATION CABLE KIT
WARNING!
Never connect generators that are different models.
• Only connect this generator to another PG4500iSR Inverter Generator.
• Only use a parallel operation cable kit designed to work with this Generator.
Fuel Tank Cap
Turn counterclockwise to remove the fuel tank cap.

Grounding the Generator

This portable inverter generator is equipped with a terminal for the connection of a
ground electrode conductor where a grounding electrode system is required by NEC
Article 250.34(A). The equipment grounding conductors of the generator receptacles
are bonded to the generator frame. Where the generator supplies power to cord and
plug connected equipment, like power tools, the frame of the generator is not required
by the NEC to be connected to an earthen ground electrode. The generator neutral
conductor is bonded to the generator frame in accordance with NEC Article 250.34(C)
WARNING!
• Only operate generator on a level surface.
• The ground terminal MUST be connected to an earthen ground if the generator is connected to a structure.
CONTROL PANEL FUNCTIONS
Generator must be properly grounded to prevent electrocution.
10