How To Stop Engine - Pulsar PG4500iSR Manual Del Operador

How to Stop Engine

• Turn the FUEL VALVE Knob to the "OFF" position.
Disconnect any electrical devices. All loads MUST be disconnected from the generator. Never start or stop the
•
engine with electrical devices plugged in to the receptacles.
• Push the One Push Start Button
• For Remote Stop push the Stop button
• Turn Battery ON/OFF Switch to the "OFF" position.
RUN
OFF
WARNING!
• Always start the engine and let it stabilize before connecting any electrical devices.
• Disconnect all electrical devices before stopping the engine.
How to Attach Electrical Devices
• Before starting generator, make sure the generator is adequately grounded, per application (see page 10 for
instructions).
• Make sure the attached load is within the generator rated output and the receptacle's rated current.
• Make sure all electrical cords and receptacles are in good condition.
• Make sure all electrical devices are turned "OFF" before plugging them into the generator.
• Start engine.
• If the attached electrical load is small, move the Economy switch to the "ON" position. For a larger electrical load,
or if attaching multiple electrical devices, move the Economy switch to the "OFF" position.
• Make sure the green AC pilot indicator light is on.
• When engine has stabilized, plug in and switch on first load. It is strongly recommended to plug in devices with
the largest electrical demand first and the smallest electrical demand last to help prevent overloading the
generator.
• Allow generator output to stabilize (engine and attached electrical devices run evenly) before plugging in the next
load.
Never start or stop engine with electrical devices plugged in to the receptacles. Failure to
heed this warning could damage the generator and/or connected electrical devices.
OPERATION
START
STOP
14
ON
OFF