Bond YH-LV80C Manual Del Usuario página 7

OPERATING INSTRUCTIONS
While fountain is designed to operate as splash free as possible, some water splashing out of the
fountain is inevitable. Place the fountain in a location where any splashing will not cause damage.
Always keep the fountain working with sufficient water and clean of debris and dirt to ensure proper
functioning of the pump.
Operating Fountain
ALWAYS MAKE SURE THE PUMP IS FULLY SUBMERGED UNDER THE WATERLINE PRIOR TO
TURNING PUMP ON.
1. Check that there is enough water in the reservoir.
2. Plug in pump cord into outlet and switch on, pump will start to work.
3. The water flow rate can be increased or decreased by moving the flow rate controller on the water
pump to the +/- signs.
4. Turn off power outlet switch, the pump will stop working.
5. Unplug fountain from outlet if not in use for a long period of time.
Adjust the flow rate to achieve the desired effect and to minimize any splashing. Splashing can occur
if the flow rate is too high or the reservoir is too full. The flow rate can be increased or decreased by
moving the flow rate control switch towards the '+/max' or '-/min' positions.
Note:
1. Drain the water if you don't plan to use the fountain for a long time to prevent mosquito breeding
and water odor.
2. Be sure to drain all water during winter months or cold seasons to prevent reservoir from cracking
or breaking.
Minimum Water Level
ensure the power cord is not dam-
Flow control valve
aged before using this appliance.
(+)Maximum
(-)Minimum
7
WARNING: Please check and