Weston Tenderizer Manual De Instrucciones página 7

5. Insert the Blade Assembly into
the Lower Housing, guiding the Drive
Shaft into the journals. Make sure
the gears and the blades of the Blade
Assembly are properly meshed together
and resting in the journals (FIGURE
D). NOTE: The Tenderizer Blade is a
2-piece set. The Jerky Slicer Blade is a
single piece.
6. Position the Top Housing onto the
Lower Housing and line up the screw
holes.
7. Secure the Top Housing to
the Lower Housing using the 2
Housing Thumbscrews. DO NOT
OVERTIGHTEN! (FIGURE E).
8. Insert the Left Comb and Right Comb
into the Top Housing (FIGURE E).
NOTE: The Left Comb is marked with
an "L" on the upper portion of the Comb.
The Top Housing is marked with an "L
Comb" and "R Comb" to aid in Comb
installation.
9. Install Handle onto the Blade Drive
Shaft. Secure the Handle to Drive Shaft
with the Handle Thumbscrew (FIGURE
F).
10. To change Blades, follow "Assembly
Instructions" 4-8 as outlined.
NOTE: Periodically the gears on the
Blades need to be tightened. Use the
Allen Wrench to tighten the screw on the
gears.
Gears
Gears
Journals
Housing
Thumbscrews (2)
Jerky blades and
Cuber/Tenderizer Blades
sold separately
Top
Housing
Lower
Housing
Drive Shaft
FIGURE D
Blade
Assembly
Drive Shaft
Journals
FIGURE E
FIGURE F
Handle
Thumbscrew
Handle
7