Cleaning Instructions; Assembly Instructions - Weston Tenderizer Manual De Instrucciones

CLEANING INSTRUCTIONS

1. Thoroughly wash all parts in soapy water. Rinse with clean water. Dry all parts
immediately. NOTE: DO NOT immerse the Blade Assembly in sudsy water where
they cannot be seen. To prevent injury, keep the Blade Assembly visible at all
times.
2. Coat all metal parts with a food grade silicone spray.
HELPFUL HINT: A long, skinny brush is helpful when cleaning the Blade
Assembly.

ASSEMBLY INSTRUCTIONS

w WARNING
1. Using an Allen Wrench and 2 Leg
Screws and Lock Washers, attach the
Support Leg to the Lower Housing
(FIGURE A). The C-Clamp should be
facing inward.
2. Install the Chute to the Top
Housing using an Allen Wrench
and the 2 Chute Screws and Lock
Washers (FIGURE B).
3. Attach the Countertop Protector Pad
to the Support Leg (FIGURE C).
4. Open the C-Clamp by turn
the screw clockwise to open the
C-Clamp. Place the C-Clamp onto
the work surface, then turn the
screw counter-clockwise until firmly
tightened.
6
Cut Hazard. Blades are sharp, use care when handling. The
use of cut-resistant gloves is suggested.
FIGURE C
Countertop
Protector
Pad
Lower
Housing
Wrench
Leg Screws (2)
Support Leg
Washers (2)
Chute
Top
Housing
Allen
Chute Screws (2) &
Wrench
Lock Washers (2)
FIGURE A
Allen
&
Lock
FIGURE B