Kobalt KCS 1224B-03 Manual De Instrucciones página 12

OPERATING INSTRUCTIONS
2. Kickback Safety Devices on This Chainsaw
Chain Brake
The chainsaw comes equipped with a chain brake,
which stops both the motor and the motion of the
chain when kickback occurs. The chain brake can
be activated by the forward motion of the chain
kickback brake handle as the saw rotates backward
during kickback; it can also be activated by the
inertial forces generated during rapid pushback.
WARNING
• Never modify or attempt to disable the chain
brake.
Make sure that the chain brake is working properly before using the chainsaw. The chain
kickback brake handle should move back and forth easily.
To test the operation of the chain brake, perform the following steps:
• Place the chainsaw on a flat bare surface and make sure no objects or obstructions that
could come in contact with the bar and chain are in the immediate vicinity.
• Disengage the chain brake by pulling the chain kickback brake handle (E) towards the front
handle.
• Start the chainsaw.
• Push the chain kickback brake handle towards the front of the saw. A properly functioning
hand brake will stop the movement of the chain immediately. If the chain brake is not working
properly, do not use the chainsaw until it has been repaired by a qualified service technician.
WARNING
• Confirm that the chain brake works properly before each use.
• If the chain brake is clogged with wood chips, the function of the chain brake may
deteriorate. Always keep the device clean.
2
Chain kickback
brake handle in
brake position
12
E