Care And Maintenance - Kobalt KCS 1224B-03 Manual De Instrucciones

OPERATING INSTRUCTIONS
• When the log is supported on both ends, cut 1/3
of that diameter from the top overbuck. Then
make the finished cut by underbucking the lower
2/3 to meet the first cut (Fig. 10e).
• When bucking on a slope, always stand on the
uphill side of the log (Fig. 10f).
• To maintain complete control when cutting
through, release the cutting pressure near the
end of the cut without relaxing the grip on the
chainsaw handles. Don't allow the chain to
contact the ground. After completing the cut, wait
for the saw chain to stop before you move the
chainsaw. Always stop the motor before moving
from tree to tree.

CARE AND MAINTENANCE

WARNING
• All maintenance should only be carried out by a qualified service technician.
• Before cleaning or performing any maintenance, remove the battery pack. For safe and
proper operation, always keep the tool and its ventilation slots clean.
• When servicing, use only identical replacement parts. Use of any other parts may create a
hazard or cause product damage.
• Always wear safety goggles or safety glasses with side shields during power tool operation
or when blowing dust. If the operation is dusty, also wear a dust mask.
• When cleaning the chainsaw, DO NOT immerse in water or other liquids.
• Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils,
etc., come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic,
which may result in serious personal injury.
Cleaning
After each use, clean debris from the saw chain and guide bar with a soft brush. Wipe the
chainsaw surface with a clean cloth moistened with a mild soap solution.
Remove the side cover, and then use a soft brush to remove debris from the guide bar, saw
chain, sprocket and side cover.
Always clean out wood chips, saw dust, and dirt from the guide bar groove when replacing the
saw chain.
1st cut overbuck (1/3 diameter)
10e
to avoid splintering
2nd cut underbuck (2/3 diameter) to
meet 1st cut (to avoid pinching)
Log supported both ends
10f
Bucking a log
Stand on uphill side when cutting
because log may roll
19