Polaroid Originals OneStep2 Manual De Usuario página 9

Box contents
01 OneStep 2 Camera
02 USB Charging Cable
03 User Manual
04 Camera Neck Strap
How to use
the OneStep
Charge the camera
Important The OneStep 2
will not be fully charged upon
purchase — it should be fully
charged before first use. To
charge the camera, plug the
USB charging cable into the Mi-
cro-USB slot on the camera's
back panel, and the other end
of the cable into a charger,
such as a smartphone adapter
or your computer's USB slot.
The red flash charge LED will
turn off when the battery is
fully charged.
A full charge usually takes
about 2 hours through a wall
socket with a smartphone
adapter, or up to 4 hours
through a computer's USB
slot. A fully-charged OneStep 2
camera will have enough pow-
er to shoot 15-20 packs of
film, depending on usage.
Remember to turn your camera
off after every use to conserve
battery life.
1. Turn the
camera on/off
To turn the camera on,
slide the power switch into the
ON position (down). The flash
charging LED on the back panel
will start blinking to charge
the flash, and the remaining
film counter on the top of the
camera will light up to indicate
that the camera is switched on.
To turn the camera off again,
return the power switch to the
OFF position.
2. Load the film
Slide the film door latch
to open the film door. Push
the film cassette all the way
in, with the film's darkslide
facing up.
Note Please check indi-
vidual film packaging for
development time, handling
and storage details.
3. Close film door
When you close the film door,
the darkslide will eject from
the camera automatically,
underneath the film shield.
The plastic film shield is
designed to protect images
from light as they develop — it
should not be removed. Take
the darkslide out from under
the film shield and let the
film shield roll back up. If the
darkslide has not ejected,
remove the film pack and
re-insert it, making sure it is
pushed all the way to the back
of the camera.
4. Set the Flash
& Lighten/Darken
Flash The camera flash will
trigger by default when you
shoot with the OneStep 2. To
shoot without the flash, press
and hold the flash override but-
ton on the back panel as you
press the shutter button.
Warning Shooting without
flash will reduce camera
performance and picture
quality in most lighting sit-
uations except brightly-lit,
sunny environments. We
recommend always shoot-
ing with flash.
Lighten/Darken Use the light-
en/darken switch on the right
side of the lens barrel to adjust