General Safety Instructions - MAC TOOLS MPF970501 Manual De Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Do not use damaged, frayed or
deteriorated air hoses and fittings.
Air powered tools can vibrate in
use. Vibration, repetitive motions or
uncomfortable positions may be harmful
to your hands and arms. Stop using any
tool if discomfort, tingling feeling or
pain occurs. Seek medical advice before
resuming use.
Do not carry the tool by the hose.
Keep body stance balanced and firm. Do
not overreach when operating this tool.
Do not use tool under the influence of
drugs, alcohol, medication, or if you are
tired.
Always turn off the air supply and
disconnect the air supply hose before
installing, removing or adjusting
any accessory on this tool, or before
performing any maintenance on this tool.

GENERAL SAFETY INSTRUCTIONS

WARNING! Read all safety warnings and all instructions. Failure to follow the warning and instructions may
result in electric shock, fire and or serious injury.
Wear personal protective equipment. Depending on application, use face shield,
safety goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and
workshop apron capable of stopping small abrasive or workpiece fragments.
The eye protection must be capable of stopping flying debris generated by various operations. The dust mask
or respirator must be capable of filtrating particles generated by your operation. Prolonged exposure to high
intensity noise may cause hearing loss. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask
if cutting operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI S12.6 (S3.19) hearing protection
• NIOSH/OSHA/MSHA respiratory protection
800.MACTOOLS
WARNING
IMPORTANT SAFETY INFORMATION ENCLOSED.
READ THIS MANUAL BEFORE OPERATING THE TOOL.
SAVE FOR FUTURE REFERENCE
WARNING
Use protective equipment such as
glasses, gloves, safety shoes, as well
as acoustic protection.
Remain vigilant, use common sense
and pay attention when using the
tool.
Always wear ANSI Z87.1 CAN CSA
Z94.3 eye protection or for Europe,
suitable CE marked eye protection
when operating or performing
maintenance on this tool.
Always wear suitable respiratory
protection when operating this tool.
Operate at 90 psig (6.2 bar / 620
kPa) Maximum air pressure.
Do not over-oil and do not use
heavy grade oil as stalling and low
performance may result.
3