Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Publicidad
Tabla de contenido
Resumen de contenidos para Redring POWERSTREAM PRO HANDBOOK RP12PT
- Página 1 Thermostatic MODEL RP12PT 240V For Service & Installation contact: BBT NORTH AMERICA Bosch Group 340 Mad River Park, Waitsfield, VT 05673 - 800-798-8161 www.boschpro.com IMPORTANT : This booklet should be given to the customer after installation and demonstration.
-
Página 2: Tabla De Contenido
Important Safety Instructions When using this electrical equipment, basic safety precautions should always be followed, including the following: 1. Read and follow all instructions. 2. This appliance must be grounded. 3. Disconnect this product from the electrical supply before cleaning, servicing or removing the cover. -
Página 3: Using The Powerstream Pro
Using the Powerstream Pro Installing the Powerstream Pro Warning Warning Do not install the Powerstream Pro in a room: Do not use the unit if you think it may be frozen, where there is a chance of freezing. as this could result in serious damage to the unit. IMPORTANT - Read entire instructions Wait until you are sure-it has completely thawed Check the pressure of the main water supply. - Página 4 Deciding the wiring route Plumbing in the unit • You have a choice of whether to feed Fitting the pipes the electric cable through the side or • The unit should be connected directly to through the back of the unit, the main cold water supply and not to pre- •...
-
Página 5: Spare Parts
WARNING • Make sure that all the terminal block The unit must be installed by a qualified screws are tightened securely. Loose electrician. connections can cause wires to neat up. The unit must be grounded. • Make sure that the ground wire is Connecting the unit to power. -
Página 6: Starting Up The Powerstream Pro
Note: Starting up the Powerstream Pro If the unit is servicing a single lever faucet you Checking for leaks may need to restrict the cold water supply to the • Lot the water run through the unit for a faucet to balance water pressure and improve few seconds. -
Página 7: How The Powerstream Pro Works
Depending on the region of the country, the How the Powerstream Pro works temperature of the water supply can vary from Water comes in through the inlet tube. 40°F in winter to about 70°F in the summer, with The flow switch senses water has passed an average of about 50°F. -
Página 8: For The Installer
FOR THE INSTALLER SYMPTOM CAUSE WHAT TO DO Electricity not on Check electrical supply. Cold water only -neon The water supply is connected to Reconnect the water supply to the light off. the OUTLET of the unit. INLET (marked in blue) The high temperature thermal cut Reset it by opening the unit and out has tripped... -
Página 9: For The User
FOR THE USER SYMPTOM CAUSE WHAT TO DO The water supply is turned off. Turn on the main supply fully at the Little or no water flows. stop valve. The flow is not high enough to Open the inlet service valve fully. Cold water only -neon activate. - Página 10 Appendix Flow vs. Temperature Setting Guide: The following graph Indicates the water temperatures the Thermostatic Powerstream Pro can achieve at different flow rates. The graph shows the maximum and minimum temperatures achievable for the 12 kW unit with the inlet water temperature set to an average ambient temperature.
- Página 12 Powerstream Pro Limited 5 Year Warranty b) The water heater has not been installed in APPLIED ENERGY PRODUCTS LTD. THROUGH ITS U.S DISTRIBUTION BOSCH WATER accordance with the applicable local plumbing HEATING (here in after BBT) guarantees this water h eater and/or building code(s) and/or regulation(s), or at the original installation location against defects in c) The water neater has not been installed in...