Using The Powerstream Pro; Installing The Powerstream Pro; Important - Redring POWERSTREAM PRO HANDBOOK RP12PT Manual Del Usuario

Using the Powerstream Pro

Warning
Do not use the unit if you think it may be frozen,
as this could result in serious damage to the unit.
Wait until you are sure-it has completely thawed
out before you switch it on.
Sink
• Check that the power is switched on
at the circuit breaker panel.
• Turn on the hot tap FULLY If you do
not turn the tap full on, you will find that
the temperature of the water may vary
The hot water can be adjusted by
altering the temperature dial and
correctly setting the flow rate. Refer to
appendix on page 10 - correct flow
vs. temperature,
• If the unit has been used recently, run
the water through for a few seconds to
let the temperature settle down. You may
initially get a short burst of very hot water
from the unit,
• It a second tap connected to the unit
is also turned on, the hot water will be
shared between the two, therefore the
flow and/or the temperature of the water
will decrease.

Installing the Powerstream Pro

Warning
Do not install the Powerstream Pro in a room:
where there is a chance of freezing.
IMPORTANT - Read entire instructions
Check the pressure of the main water supply.
To operate correctly the unit needs the following
running pressures:-
Sink
Min: 20psi (1.4 bar)
Max: 150psi (10.3 bar)
Securing the unit to the wall
Deciding the position
• If being used in a public place, position
the unit out of reach to discourage
vandalism.
• Mount the unit onto a flat section of wall,
well away from any potential splashes of
water or spray.
• Position the unit lengthways (diagram 1.)
Remember to keep the length of hot
water pipe to a minimum in order to save
energy.
• If the unit is to supply a sink, you can It
it either above or below the sink.
Warning
Unit must be mounted as shown
'Lengthways' with plumbing connection
pointing down. Under no circumstances
should the unit be mounted differently.
3