HAMPTON BAY Victoria El Manual Del Propietario página 9

A t t a c h i n g t h e F a n
Blades
1. Attach the fan blades to the blade
holders by using three screws and fiber
washers as shown in Figure 13. Start a
screw into the blade holder, do not
tighten. Repeat for the 2 remaining
screws and washers.
2. Tighten each screw securely starting
with the center screw.
3. Fasten the blade assemblies to fly
wheel with the blade holder attachement
hardware(B) provided. (Figure 14)
4. Loose five PCS motor screws on the
motor, Place the slot holes of the fly
w h e e l o v e r f i v e s c r e w s p r e v i o u s l y
loosened and attach five motor screws
provided in Loose parts bag, tighten all
screws. (Figure 15)
Screws
paper
Washer
Screws B
Flywheel
Figure 15
Figure 13
Blade
Blade holder
Figure 16
The following procedure should correct most
Figure 14
fan wobble issues. Check after each step.
1. Check that all blades and blade holder
screws are secure.
2. Most fan wobble problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling above
the tip of one of the blades. Measure this
distance as shown in Figure 16. Rotate the fan
until the next blade is positioned for
measurement. Repeat for each blade. The
distance should be equal within 1/8".
If all blade levels are not equal, you can
adjust the blade level with the following
procedure.
3. Use the enclosed Blade Balancing Kit if the
Screws B blade wobble is still noticeable. (Please refer
to the introduction provide in the blade
balancing kit, which is individually packed.)
4. If the blade wobble is still noticeable,
Touching
ceiling interchanging two adjacent (side by side)
blades can redistribute the weight and
possibly result in smoother operation.
6