Transmitter Operation; Operating The Fan; Operating Your Fan 9 - HAMPTON BAY Pendleton El Manual Del Propietario

Transmitter Operation

Remote Control - Your fan is equipped with a
remote control to operate the speed and light for
your new ceiling fan. For more information on
how to install the remote control, see the remote
control instruction along with the remote con-
trol components.
NOTE: This remote is equipped with 16 code
combinations. To prevent possible interference
from or to other remote units such as garage
door openers, car alarm or security system, sim-
ply change the combination code but be sure
that the code on both the hand held transmitter
and receiver in the fan are matched.
Install a 9 volt battery (not included).

Operating the Fan:

Hi Key - High Speed
Med Key - Medium Speed
Low Key - Low Speed
Off Key - Power Off
Light Key - Light On/Off
Speed settings for warm or cool weather depend
on factors such as room size, ceiling height,
number of fans, and so on.
The fan shipped from the factory with the re-
versing switch positioned to circulate air down-
ward. If airflow is desired in the opposite direc-
tion, turn your fan off and wait for the blades
to stop turning, then slide the reversing switch
(located at the top of the motor housing, refer
to figure 7 on page 5) to opposite position, and
turn fan on again. The fan blades will turn in the
opposite direction and reverse airflow.
Warm weather - (Forward) A downward air
flow creates a cooling effect as shown in Figure
15. This allows you to set your air conditioner
on a higher setting without affecting your com-
fort.
Cool weather - (Reverse) An upward air flow
moves warm air off the ceiling are as shown in
Figure 16. This allows you to set your heating
unit on a lower setting without affecting your
comfort.

Operating Your Fan 9.

Figure 15
Figure 16