Operation - HAMPTON BAY 69156 Guía De Uso Y Mantenimiento

Ventilador de techo altura, de 1,42 m
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Your Fan and Remote Control
Learning process
Should you desire to use another remote control unit with your
new fan, install one using the steps below:
Turn the main power source off to being the learning process.
Remove the remote control battery cover to set the dip switches to the
desired combination. Use a small size tool, such as a ball-point pen
or small screw driver, to change the frequency settings on the control
system. The receiver will automatically learn the frequency code.
Return the power to the unit.
NOTE: After the AC power is on, do not press any other button on the
remote control before pressing the "FAN OFF" button. Doing so will cause
the procedure to fail.
Within 30 seconds of turning the Fan's AC power ON, press and hold
the "FAN OFF" button for 5 seconds. Once the receiver has detected
the set frequency, the down light of your fan, if applicable, will blink
twice. There is no indication if your fan is not equipped with a light.
NOTE: The remote control can learn multiple receivers. Make sure no
other receivers are operating during the learning process. Separate the
fan power switches by approximately 2 meters.
Remote control operation
NOTE: This remote is equipped with 16 code combinations. To prevent
possible interference from or to other remote units, such as garage
door openers, car alarms, or security systems, simply change the
combination code. The code switch marked ON/D is for dimming
control of the lights: Set the code switch to ON to allow for no dimming
of the lights such as for fluorescent bulbs. Set the code switch to D to
allow for dimming of the lights.
Install a 9-V battery (included).
NOTE: If using a light kit, the light switch located on the light kit
should be at "ON" position before operating the remote control.
Operating the fan
Light/Dimmer button = Press and release the button imme-
diately to turn on or turn off the light. Press and hold the
button to dim or brighten the light to the desired level and
then release.
(For tungsten bulbs only and down light function, turn the
switch to "D".)
Low button = Low speed
Medium button = Medium speed
High button = High speed
Off button = Power off
Reverse button = Press and release the button immediately
to set the fan air flow direction up or down.
13
Please contact 1-877-527-0313 for further assistance.
HAMPTONBAY.COM

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

56-atr

Tabla de contenido