Quick Start - Aetertek AT-918C El Manual Del Propietario

Quick Start

1
2
3
Step 1:
Screw the
antenna tightly onto
the transmitter.
Step 2:
Charge the
transmitter. The signal
light will flicker until
battery is fully charged.
Step 3:
Screw the metal
prongs onto the receiver till
the prongs are securely
attached. Normally, they
are assembled in the factory.
Step 4:
LED light of the receiver will be on while the
receiver is charging. When the receiver is
fully charged, the BLUE LED will be on. Once
you unplug the charger, the RED LED light
will stay solid on-waiting for sync. At the
4
same time, the Blue LED light will go off.
Tip 1: It is recommend to charge the transmitter and receiver for up to
3 hours for the first 3 times.
Place the magnet on the
transmitter near to the
magnet switch on the
receiver until the receiver
vibrates. The red light will be
on, indicating that the receiver
is started.
ON/OFF area
5
Step 5:
Turn the receiver on/off. Bring the magnet on the
transmitter near to the magnet switch on the receiver until
the receiver vibrates. At that time, the red light will be on
/off, indicating that the receiver is started/off. If you just
finish charging, unplug the charger, and the receiver is on
already.
Tip 2: To do a self-test, place the magnet on the transmitter near to the ON/OFF
area on the receiver for 3 times, and the receiver will beep, vibrate or shock with
the blue light on, indicating the receiver works normally.
Charge the receiver. The RED
-02-