Uline H-7053 Manual Del Usuario página 2

Figure 2
Lever
Figure 3a
Figure 4
PAGE 2 OF 9
ASSEMBLY INSTRUCTIONS CONTINUED
Figure 3b
2. Slide armrest into bracket on bottom of seat cushion
until it clicks. Push in lever toward armrest to lock.
Repeat on opposite side. (See Figure 2)
3. Position back support in slot between bottom of
seat cushion and mechanism. Align holes and use
three screws with washers to attach back support to
mechanism. (See Figures 3a - 3b)
NOTE: Use Allen wrench to tighten all screws.
4. Slowly lower assembled chair and insert center
of mechanism into gas lift. Press down on seat to
secure in place. (See Figure 4)
0521 IH-7053