Memory Mode; Selecting A Temperature Scale; Care And Cleaning; Battery Replacement - STIL 6040 Consejos De Uso

MEMORY MODE

1. The Memory Mode can be accessed ether in forehead mode or object mode:
When the thermometer has been turned on and followed by Figure 4/6 or finished
testing, press and hold the
in the center right corner of the display. (See Figure 4)
2. The thermometer will automatically memorize the last 10 temperature readings.
Each memory also records the measurement date/time/mode icon. Each time the
BUTTON is pressed, the screen displays past readings that correspond with
a number 1-10. The number 1 reflects the most recent reading, while the number
10 reveals the oldest reading stored in memory.(See Figure 5)
3. In the memory mode, mark or
BUTTON to take new measurements.

SELECTING A TEMPERATURE SCALE

1. Temperature readings are available in the Celsius (°C) or Fahrenheit (°F) scale.
2. With the thermometer off, press and hold the START BUTTON for 3 seconds.
3. Press and release START BUTTON to select the unit.
4. When the preferred unit on the display, press
mode.

CARE AND CLEANING

1. The probe window must be kept clean, dry, and undamaged at all times to ensure accurate readings. The accuracy of temperature readings
can be affected by damage to the probe window, or the presence of dirt, fingerprints, earwax, dust and other soiling compounds on the probe
window. Degraded sensors can degrade performance or cause other problems.
2. The probe window is the most delicate part of the thermometer. Use a soft cloth slightly moistened with a 70% isopropyl alcohol solution
to disinfect probe window and the thermometer. Do not use abrasive cleaners. After cleaning, allow at least 10 minutes drying time before
taking temperatures. Note: Do not use any chemical other than isopropyl alcohol to clean the probe window.
3. Use a soft, dry cloth to clean the thermometer display and exterior.
4. The thermometer is not waterproof. Do not submerge the unit in water when cleaning.
5. Store the thermometer in a dry location, free from dust and contamination and away from direct sunlight.
6. Strong electromagnetic fields may interfere with the proper operation of the thermometer. The device needs special pre-cautions regarding
EMC according to the EMC information.
7. Put the thermometer back to the original packaging after using.

BATTERY REPLACEMENT

1. Replace battery when «
appears in the upper right corner of LCD display. (See Figure 7)
2. Slide battery cover down as shown in Figure 8.
3. Remove battery and install 2 new AAA alkaline batteries
as shown in Figure 9.
4. Slide battery cover back on.
BUTTON for three seconds. The letter M will appear
mark always exist. The user can press the START
BUTTON to exit the unit changing
»
Fig.7 Fig.8
Fig.4 Fig.5
Fig.6
Fig.9
15