Intended Use; Symbol Meaning - GreenWorks SDS Instrucciones De Seguridad

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
type drill chuck are required.
■ The quick change chuck is automatically
locked. Check the locking effect by
pulling the quick change chuck.
■ Inserting SDS-plus Drilling Tools: Check
the latching by pulling the tool.
■ Replace a damaged dust protection
cap immediately. The dust protection
cap largely prevents the penetration of
drilling dust into the tool holder during
operation. When inserting the tool, pay
attention that the dust protection cap is
not damaged.
■ Dusts from materials such as lead-
containing coatings, some wood types,
minerals and metal can be harmful
to one's health and cause allergic
reactions, lead to respiratory infections
and/or cancer. Materials containing
asbestos may only be worked by
specialists.
– As far as possible, use a dust extraction
system suitable for the material.
– Provide for good ventilation of the
working place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
■ Prevent dust accumulation at the
workplace. Dusts can easily ignite.
■ To save energy, only switch the power
tool on when using it.
■ Apply the power tool to the screw/nut
only when it is switched off. Rotating tool
inserts can slip off.
■ If the application tool should become
blocked, switch the machine off. Loosen
the application tool.
■ When switching on with a blocked drilling
tool, high torque reaction can occur.
■ Always wait until the machine has come
to a complete stop before placing it
down. The tool insert can jam and lead
to loss of control over the power tool.
■ Avoid unintentional
Ensure the On/Off switch is in the off
position before inserting battery pack.
Carrying the power tool with your finger
on the On/Off switch or inserting the
battery pack into power tools that have
the switch on invites accidents.
■ Do not open the battery. Danger of
short-circuiting.
English (Original Instructions)
switching on.
Protect the battery against heat, e. g.,
against continuous intense sunlight,
fire, water, and moisture. Danger of
explosion.
■ In case of damage and improper use
of the battery, vapours may be emitted.
Ventilate the area and seek medical
help in case of complaints. The vapours
can irritate the respiratory system.
■ Use the battery only in conjunction with
your power tool. This measure alone
protects the battery against dangerous
overload.
■ Use only original batteries with the
voltage listed on the nameplate of your
power tool. When using other batteries,
e.g. imitations, reconditioned batteries
or other brands, there is danger of injury
as well as property damage through
exploding batteries.
■ The battery is supplied partially charged.
To ensure full capacity of the battery,
completely charge the battery in the
battery charger before using your power
tool for the first time.
■ Read the operating instructions of the
battery charger.
■ Check the tight seating of the battery.
Two locking levels are possible.

INTENDED USE

■ The machine is intended for hammer
drilling in concrete, bricks and masonry,
as well as for light chiselling work. It is
also suitable for drilling without impact
in wood, metal, ceramics and plastic, as
well as for screwdriving.
SYMBOLS
The following symbols are important for
reading and understanding the operating
instructions. Please take note of the symbols
and their meanings. The correct interpretation
of the symbols will help you to use the
machine in a better and safer manner.

Symbol Meaning

Safety alert
CE Conformity
Read all safety warnings and
all instructions
4