Star CS511 Manual Del Usuario

WARNING:
FOR YOUR PROTECTION, ALWAYS DISCONNECT
PUMP FROM POWER SOURCE BEFORE HANDLING.
2. Attach discharge hose (not provided) to pump
(A) outlet. A standard 3/4 in. garden hose may be
used as a discharge line.
Keep the total length as short as possible for best
performance.
OUT
4. Plug in power cord to grounded outlet. Pump
(A) will prime in a few minutes, depending on
suction line length.
OUT
Toll Free Help Line: 1-800-742-5044
UTILITY
TRANSFER
PUMP
MODEL #CS511
QUICK START
GUIDE.
SEE INSTRUCTION
MANUAL FOR
COMPLETE DETAILS.
IN
IN
1. Pump (A) should be located within 15 ft. of the
water source, and strainer (C) should be used at the
end of the inlet line. Attach hose adapters (B) and
suction hose (not provided) to pump. Make sure inlet
connection is air tight.
NOTE: Regular garden hose should not be used on
pump (A) inlet. It will collapse when the pump runs.
A
3. Remove priming plug from the top of pump (A).
Fill pump (A) housing with clean water. Reinstall
plug.
DO NOT RUN DRY.
5. If the pump does not pump water after five minutes,
turn off the pump and repeat steps 1 through 3.
DO NOT RUN DRY.
Printed in China
C
B
SW1009 B