Blade Balancing Instructions - allen+roth LP8242LCH Manual Del Usuario

BLADE BALANCING INSTRUCTIONS

If the fan wobbles when in use, turn off the fan and follow the below steps:
WARNING
The balancing clip must always be firmly pushed
onto the blade until it touches the edge of the
blade. Failure to do so could allow clip to fly off
and cause personal injury.
1. Interchanging positions of adjacent blades (P)
can redistribute the weight and result in
smoother operation. If wobble decreases,
leave blades (P) as they are. If wobble
increases, switch back to original position.
Attach the balancing clip from the balance kit
(DD) to the mid-point on the top edge of one
blade (P).
2. Run the fan at high speed (air downflow) and
observe wobble. Repeat steps 1 and 2 for
each blade (P). Note which blade (P) has the
least wobble. On that blade (P), install the
balancing clip (DD) to the top edge of the
blade (P) near the motor assembly (A).
Start the fan and observe wobble. Stop the fan
and move the balancing clip (DD) in small
steps toward the end of the blade (P). At each
incremental step, turn on the fan and observe
the wobble. Determine the location of the
balancing clip (DD) that gives the least amount
of wobble.
3. Peel the backing paper from one of the
weighted squares in the balance kit (DD).
Secure the weighted square firmly to the top of
the blade (P), centered at the balancing clip
location and between the edges of the blade
(P). Remove the balancing clip, start the fan
and observe. If the wobble still persists, repeat
steps 1 through 3 until the wobble disappears.
1
2
3
Lowes.com/allenandroth
18
DD
P
DD
P
DD
P