Basic Operation - yellow jacket 52070F Instrucciones De Operación

ICONS AND INDICATORS ON THE LCD DISPLAY
°C/°F/k Temperature Units
H Max Temperature Readings
C Minimum Temperature Readings
Hold
Freezing Image Icon
AM
12 Time Format
IRON Color Palette
Unlock Icon
Centre Crosshair
Hot Crosshair
Cold Crosshair
Bluetooth Icon
®
Battery Empty
Battery Full
Battery Charging
Lock Icon
TURNING THE THERMAL IMAGER ON AND
CHARGING THE BATTERY
Press and hold the Power Button for greater than 2 seconds to turn the
thermal imager ON. A start-up screen (a thermal image) will appear. The
unit is now ready to use. To turn the imager OFF, press and hold the Power
Button for greater than 2 seconds. Note: The 52070F has an Auto Power
Off function which automatically turns the thermal imager off after a period
of inactivity. You can set the Auto Power Off time in the Set Up Menu
With the thermal imager ON, the battery level indicator will display the
current battery power level. If the battery power is low, connect to an AC
source or a computer USB port using the supplied USB cable (USB connec-
tion port is located at the top of the imager).
When the imager is powered OFF, the battery charging red LED will turn on
when the imager is connected to an AC source or connected to a computer
USB port. The battery is fully charged when the red charge indicator LED
turns off.
The imager can also be turned ON and in use while the battery is charging.

BASIC OPERATION

The 52070F thermal imager is intuitive and easy to use. The 52070F has an
IR resolution of 80 x 80 or 6400 temperature measurement points. Here
are the basic steps (Covered in more detail later in this Guide):
1.Press and hold the Power Button for greater than 2 seconds to turn
the imager ON. The startup screen will appear followed by a thermal
image on the display. Take note of the battery charge level.
2.Point the unit toward the area or object of interest and view the
thermal image. Relative temperature is represented by color, hot
to cold. The Center Temperature Reading (large temperature reading
on the bottom of the LCD display) represents the temperature at the
Center Crosshair. At the same time, the hottest and coldest point
temperatures in the scene will be displayed on the screen.
3. Press the trigger briefly to capture an image of the scene. Press the
OK button to save the image. Press "SHARE" to send the image to a
Bluetooth connected smart device. Press the Trigger again to
®
discard the image.
4. Press "LOCK" to lock the current scene temperature range. Press
"LOCK" again to un-lock the current scene temperature range.