Install The Hardware - Axis T8082 PS57 CHASSIS 2KW 1U Guia De Instalacion

AXIS T8082 PS57 CHASSIS 2KW 1U
Input voltage
Input frequency
Output voltage
Power factor
Efficiency
Input current
Overload
protection
Connectors
Power Connector
AC connector for power input.
2-pin terminal block for DC power output.

Install the Hardware

Note
• The AXIS T8082 is designed for use with AXIS T8646 PoE+ Over Coax Blade only.
• The AXIS T8088 PS57 Distribution Board is designed for use with AXIS T8080 PS57
Chassis 1U only.
• The power patch cables are very short. If the chassis with the blades is installed on a slide
rail, the power distribution board must be attached to the bottom of that chassis.
• All components shall be installed and connected before the system is powered up.
Install the Power Distribution Board
1. To attach the power distribution board to the bottom of the chassis:
AXIS T8081
100–240 V AC
50/60 Hz
57 V DC
> 0.95
Up to 90%
Max. 12 A
120% Overload
12