BEFORE USING FOR THE FIRST TIME
1. Notice when the removable airtight lid is properly closed, the arrows on the base handle
and lid will be lined up. To remove the lid, holding the base handle firmly with one handle,
grasp the lid handle with the other hand and rotate counter-clockwise. Follow the arrow
on the lid handle (See Figure 4)
FIG. 4
asket
older
2. Remove and wash the stainless steel removable cooking pot, lid, silicone gasket and
gasket holder in warm soapy water and 1/4 cup of vinegar to 2 cups of water. (See Care
and Cleaning Instructions for disassembly details). Rinse with clean water and dry
ator
thoroughly.
et
3. Replace clean silicone gasket. Make sure the silicone gasket is attached properly to the
gasket holder and is securely in place on the lid. (See Care and Cleaning Instructions for
assembly details).
WARNING: IMPROPER REMOVABLE AIRTIGHT LID ASSEMBLY COULD RESULT IN APPLIANCE
MALFUNCTION AND CAUSE THE UNIT TO STOP OPERATION AND POSSIBLY CAUSE INJURY.
4. Clean and dry the bottom of the removable cooking pot as well as the heating plate with
temperature sensor, making sure there are no unwanted materials on the surface. The
removable stainless steal cooking pot must sit flat on the heating plate with temperature
sensor to ensure proper control.
5. Place the Ultra Cooker on a flat heat resistant level surface, approximately 2 feet from a
standard 120V AC electrical outlet. DO NOT let cord hang over the edge of a table or
countertop.
d that
6. When cooking under pressure, never place the Ultra Cooker under cabinets. When
releasing steam, make sure the area several feet above the pressure release valve is clear
Gauge
from all lighting fixtures, furniture or cabinetry.
High
7. Connect the detachable power cord pushing firmly into the receptacle at the back of the
Ultra Cooker.
BEFORE EACH USE
Always check the removable airtight lid to ensure that the pressure release valve and pressure
indicator rod slides easily and is in good working order and that there are no foreign particles
blocking the valve openings on the underside of the lid. Check to see that the silicone gas-
ket is attached properly to gasket holder and the gasket holder is contained within the grips
along inside of the lid. (See Care and Cleaning Instructions for assembly details).
9