Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
power Button
NOTE: When
"POWER" button
To turn on the massage functions,
is pressed for
first press the POWER button. The
first-time use, the
L.E.D. indicator will illuminate and confirm
your selection. To turn off the massage
moving mechanism
functions, simply press the button again.
will automatically
The L.E.D. indicator will blink while the
move to the lowest
massage mechanism returns to its lowest
position before
point and then it will turn off.
starting a massage
program. After initial
Kneading massage
use, mechanism
Kneading is a deep massage.
will always park at
lowest position. See
massage Zones
note below regarding
Choose from 3 preset zones in
parking.
Rolling or Kneading where the
massage travels up and down in
a specific area of the back, full,
upper or lower. To select a program,
simply press the button and the
L.E.D. will illuminate. To deselect,
press the button again or press
another button.
NOTE: The moving
spot massage
massage mechanism
While the unit is in Kneading
always "parks"
massage, press either button to stop
or finishes in its
and focus the Shiatsu action in one
lowest position. It
place. Once the unit is operating
will continue to this
in Spot Massage, you may adjust
position after the
the mechanism position by holding
down either button until the desired
power has been
position is reached. The Up Arrow
turned off. If the
will move the mechanism upwards
electrical supply is
and the Down Arrow will move it
interrupted, when
down. Once you release the button,
power is restored,
the mechanism will stop in that
the mechanism will
place.
"park" or move to
its lowest position.
8
Full Back Cushion with
Custom Fit Massage
demo Button
For a brief demonstration of the features of the Massage cushion, press
the Demo button. The unit will briefly go through each function. Once
completed, the unit automatically turns off. The L.E.D. light will blink to
indicate active function.
perfect Fit
To customize the massage to your height, press the PERFECT FIT
button at the highest desired position while the massage function is
on. The massage heads will not travel higher than the selected position
for the duration of the massage. To deselect, press the PERFECT FIT
button a second time.
rolling massage
Rolling is like two hands working slowly up and down your back.
Width adjustment
While the unit is in Rolling massage, press this button to adjust the
distance or width between the massage heads. With each press, the
massage heads will move to the next available position.
Heat Button
For soothing heat, when massage is on, simply press the heat button
and the corresponding red L.E.D. light will illuminate. To deselect,
press the button again and the corresponding L.E.D. light will turn off.
For your safety, heat cannot be turned on if no massage program is
selected.
NOTE: There is a 15-minute auto shut off
on the unit for your safety.
9
with Heat
Publicidad
Tabla de contenido
