Saivod 12H Manual De Instrucciones página 19

for the yellow line. Stop pulling the power cord once the yellow line is visible.
There is also a red line, which indicates the end of the usable cord. Do not pull the power cord
out beyond the red line.
Before using your vacuum, make sure that the dirt cup and all filters are in place. Do
not operate your vacuum without the dirt cup and filters.
Be careful to avoid injury as cord retracts very quickly
Plastic film can be dangerous. To avoid danger of suffocation, keep away from
babies and children.
Air flow regulator (2)
Open the air flow regulator by sliding the regulator down towards the extension wand to
an open position. This will reduce the suction power for vacuuming delicate fabrics.
For full suction power, close the air flow regulator by sliding the regulator up to the closed
position.
MAINTENANCE
4. Empty the dust cup :when the wind indicator turns to be red, it is time to clear the dust
cup. (Fig 9,10)
Take off the cup from the body by pulling the lock clip.(Fig 9)
Open the cup bottom cover by pushing the button. (Fig 10)
Install the dust cup: Push the cup bottom cover until locked, put back the cup to the main
body. (Fig 9)
Make sure the cup is installed with the HEPA. (Fig 11)
5. Inlet filter: clean the filter with warn water once a year and you can install it after dry. If
the filter is damaged, a new filter should be replaced.
6. Clean the filter: open the outlet cover and take out the HEPA frame and filter. Wash it
and install it after dry.(Fig 12,13)
Fig 1 Fig 2 Fig 3