Publicidad
Enlaces rápidos
Model Specific Install Guide
Hardware Kit Check List
1
A. Mounting Bolts (2)- M8 Flange
bolts & (4)- M6 Flange bolts )
B. Bulkhead Seal (1)
C. Pre- Staked Cover Retainer
Assemblies (2)
D. Drain Tubes (2)
1. Install the bulkhead seal on top of the front
bulkhead of the bed, centering the bulkhead seal
front to back. Make sure to place the bulkhead seal, so
that both ends set flush against the inside edge of the
plastic bed rail caps, ( driver to passenger side ). Trim
to fit.
UX-G_Install
Created June 2019
Part Number - UX-G
2020-C Jeep Gladiator JT Applications
www.undercoverinfo.com
2. Locate the outlined section on the inside of the bed
cap towards the tail light well at the rear of the bed. Cut
and remove the outlined section of bed cap to reveal
threaded holes. Repeat process for both Driver and
Passenger side.
UX-G
KIT - G
Driver Rear
© 2017 UnderCover, Inc.
All rights reserved.
Publicidad
Resumen de contenidos para Flex UX-G
- Página 1 Repeat process for both Driver and plastic bed rail caps, ( driver to passenger side ). Trim Passenger side. to fit. © 2017 UnderCover, Inc. All rights reserved. UX-G_Install www.undercoverinfo.com Created June 2019 Part Number - UX-G...
- Página 2 MODEL SPECIFIC GUIDE 2020-C Jeep Gladiator JT Applications Attach Side Mounting Rails Driver Rear Driver Front 3. Using one of the M8 Flange head bolts, install the 4. Install the rear portion of each mounting rail, using driver side mounting rail to the front bulkhead with the M6 Flange head bolts and thread them into the using the lower hole in the flange on the front of the pre- threaded holes located previously from the...
- Página 3 à ce que les deux extrémités affleurent le bord intérieur des capuchons de glissière de lit en plastique (côté conducteur à passager). Couper pour s'adapter. © 2017 UnderCover, Inc. All rights reserved. UX-G_Install Created June 2019 Part www.undercoverinfo.com Number - UX-G...
- Página 4 Guia De Instalacion Espacifico a Modelo | Modèle Guidespécifique 2020-C Jeep Gladiator JT Aplicaciones Fije los rieles de montaje / Fixez les rails latéraux de montage Driver Rear Driver Front Instale la parte trasera de cada riel de montaje, utilizando los Con uno de los pernos de cabeza de brida M8, instale el riel de pernos de cabeza de brida M6 y enrosque en el Orificios previamente montaje del lado del conductor en el mamparo frontal utilizando el...