For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• To be used with Lund® branded products only.
• Do not stand on Lund running board or bracket while vehicle is in motion.
• Do not use the brackets as a jacking point for the vehicle.
• Do not use the bracket system or running boards to fasten cargo.
• Periodically check all components for tightness.
• Be sure to wear safety glasses while installing brackets.
•When using power tools, read and understand all operating instructions.
Contents
NOTE: Actual product may vary from illustration.
Driver Side Running
Board
Driver Front
Bracket x1
Tools Required
Ratchet and Extension
Preparation Before Installation
• Park your vehicle in a clean, level location. Check to make sure the vehicle is in park, or for manual drive models, place the
transmission in first gear. Engage the parking brake. Chock wheels.
• Unpack the kit and identify the parts according to the content descriptions.
• An assistant is recommended to help position the running board properly during the installation.
Installation Instructions
Latitude Nerf Bar for Jeep Wrangler
For proper installation and best possible fit, please read all instructions BEFORE you begin.
Passenger Side Running
Board
Driver Mid
Driver Rear
Bracket x1
Bracket x1
Socket Set
Bolt x12
Lock Washer x12
Passenger Front
Bracket x1
Wheel Chocks
Page 1 of 3
I - Sheet Number LUNDRB17 Rev.A
Lund Part# 26510023
Flat Washer x12
Passenger Mid
Passenger Rear
Bracket x1
Bracket x1
Safety Glasses
26610023