7
/
pROGRAMMInG :
LIGHt On / LIGHt OFF tHE tIMER :
To light on the timer, press more than 5 seconds on the button
The red LED will flash every 5 seconds : the timer is ready to be used.
Repeat the operation to light off the timer. The LED will stop flashing.
Save water by programming the watering of your outdoors plants early in the morning or
late in the evening (when water evaporates the least). The timer will start watering auto-
matically as set and will work during your holidays.
There are two ways to program the watering of your garden : automatic or manual.
1. AutOMAtIc RunnInG :
Set the FREQUENcY and RUN TIME watering time selectors as desired.
The watering program is set and will run automatically according to the values programmed.
You can change the program at any time by turning the selectors on new values.
!
Any modification of settings will modify the start time depending on the
time it is when you set the timer.
2. MAnuAL RunnInG :
a) To start watering immediately for an indefinite time : position the RUN TIME switch on
ON, then on OFF to stop the manual watering.
To resume the programmed cycle, set the RUN TIME selector on the desired value.
b) To start watering immediately for 15 min : press 1 second on the button
of the timer. Manual watering will start and will turn off automatically after 15 minutes.
!
The FREQUENcY setting must always be greater than the RUN TIME
setting, otherwise the setting will not work.
3. OFF MODE :
To stop a running program or to turn off the manual watering, position the RUN TIME selector
on OFF.
To reactivate it, you must set your device again.
4. DELAY FunctIOn :
delay watering with the delay option :
Press on the DELAY button more than 2 seconds until the LED lights up then release the
button.
Each time you press on the button will delay the programming 1 hour until the next watering.
Press as many times as necessary: from 1 to 23 hours.
To cancel the 'Rain Delay', turn the FREQUENcY selector on another position.
, at the back of the timer.
En
at the back
15