Installation - Glacier bay FS6AC071CP Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply. Remove the old faucet.
Clean off the mounting surface.
Remove the lock nuts (E), metal washer (D) and
rubber washer (C) from the faucet.
WITHOUT DECK PLATE: Insert the supply lines (H) and
lift rod (P) through the mounting hole in the sink until
faucet (A) sets on top of the sink.
WITH DECK PLATE: Align the hole in the gasket (G)
and deck plate (F) with the mounting hole in the
sink. Insert the supply lines (H) and the lift rod (P)
through the deck plate (F) and mounting hole in the
sink until faucet (A) sets on top of deck plate (F).
F
1
G
NOTE: If the sink is uneven, use silicone under the
gasket (G).
2
A
P
H
A
P
H
2
1
4
Securing the faucet
Slide the rubber washer (C) and metal washer (D) over
threaded rods and lift rod (P). Use the lock nuts (E) to
secure the rubber washer (C) and metal washer (D).
Attach the extension rod (U) to one lock nut (E), feed a
screwdriver (not included) through the bottom of the
extension rod (U), and then tighten the lock nut (E).
Repeat for the second lock nut (E).
P
1
C
D
E
U
2