Maintenance; Emptying The Collection Tank; Installing & Cleaning The Cartridge Filter - Craftsman 125.12002 Manual Del Operador

Maintenance

Emptying the Collection Tank

1 2
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the vacuum.
(Fig. 2)
3. Undo the latches and remove the
power head from the collection tank.
(Fig. 3)
4. Clear all dirt or debris from the
collection tank and hose. (Fig. 4)
5. Clean the foam fi lter by washing it with
water and mild soap. (Fig. 5)
6. Check the hose, attachments, and
power cord to verify that they have not
been damaged.
IMPORTANT! Clean or change the
cartridge fi lter regularly for best
performance.
!
WARNING: Always disconnect the plug from the power outlet before removing
the power head from collection tank.
Installing & Cleaning The Cartridge Filter
1 2
Installing Cartridge Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Remove power head and place in
upside down position.
3. Install the cartridge fi lter over the fi lter
cage and carefully push fi lter in until it
stops against the power head.
(Fig. 2 & 3)
4. Place fi lter retainer on top of cartridge
fi lter and tighten down by turning
retainer clockwise. (Fig. 4 & 5)
3 4
ALWAYS USE DUST FILTER FOR DRY
VACUUMING. If the machine is used
without the cartridge fi lter, the motor will
burn out and the warranty will be voided.
Always keep spare fi lters on-hand.
NOTICE! The fi lters included are made
of high quality material designed to stop
small dust particles. The cartridge fi lter
should be used for dry pick-up only. A
dry cartridge fi lter is necessary to pick up
dust. If the cartridge fi lter is wet, it will
clog quickly and be very diffi cult to clean.
Handle the fi lter carefully when removing
it for cleaning and replacing it. Check
the fi lters for tears or small holes, a small
hole can let dust pass through and out of
the cleaner. Do not use a fi lter with holes
or tears in it, replace it immediately.
4
3
Removing and Cleaning Cartridge Filter
1. Unlock and remove the fi lter retainer
2. Carefully hold and pull the cartridge
3. Clean the cartridge fi lter by gently
10
5
5
by turning retainer handle counter
clockwise.
fi lter up for removal. (Fig. 6)
tapping or brushing dirt off. Cleaning
should not be done indoors in living
areas. For optimal performance a new
fi lter is recommended.
6