Operation; Checking For Leaks - HAMPTON BAY ROSEMARKET CHAT XSC1786 Guía De Usuario Y Cuidados

Operation

1
Installing a gas tank
□
Open the drawer and place the 20 pound gas tank
on the tank support (G).
□
Secure the tank on the base by using the tank strap
(O). Attach the tank strap to the hook on the drawer
panel (H).
□
Attach the fire bowl to the gas tank with the hose
from the fire bowl.
□
Close the drawer (H).
NOTE: To operate, you will need a standard 20
pound propane tank.
WARNING: Follow all leak-checking procedures
before operating. To prevent fire or explosion
hazard when testing for a leak:

Always perform a leak test before lighting the
outdoor fire pit table and each time the tank is
connected for use.

No smoking. Do not use or permit any possible
sources of ignition in the area while conducting
a leak test.

Conduct the leak test outdoors in a well-
ventilated area.

Do not use matches, lighters, or a flame to
check for leaks.

Do not use the outdoor fire pit table until any
and all leaks are corrected.
If you are unable to stop a leak, disconnect the LP
gas supply. Call a gas appliance serviceman or
your local LP gas company.
2

Checking for leaks

□
Mix two to three ounces of a soapy solution to check
for leaks. Use one part liquid dishwashing detergent
and three parts water.
□
Apply several drops of solution where the hose
attaches to the regulator.
□
Apply several drops of solution where the regulator
connects to the cylinder.
□
Make sure all fire pit and ignition valves are off.
□
Turn the cylinder valve on.
□
If any soap bubbles are visible where the solution has
been applied, the connections must be tightened
another turn and the leak check must be performed
again.
NOTE: If burner fails to remain lit, close all
valves and wait 5 minutes before attempting to
light the fire pit again.
13
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM