Technical Data; Charging Procedure - Worx WA3764 Manual Del Usuario

Cargador de vehículo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. BATTERY PACK*
2. CHARGER
3. CHARGE INDICATOR LIGHT
* Not all the accessories illustrated or
described are included in standard delivery.
We recommend that you purchase your accessories
listed in the above list from the same store that
sold you the tool. Use of any other accessory or
attachment may increase the risk of injury. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.

TECHNICAL DATA

Rated Input voltage
Output voltage
Charging current
Rated Input power
Charge battery
4
Charging time (approx.)
Battery pack:
2.0Ah
4.0Ah
Machine weight
For the technical data of the types, the number of
cells and the rated capacity of the batteries that can
be charged, please refer the nameplate of the battery
pack supplied by WORX.

CHARGING PROCEDURE

NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack
are specifically designed to work together
so do not attempt to use any other devices. Never
insert or allow metallic objects into your charger
or battery pack connections because an electrical
failure and hazard will occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must
Vehicle Charger
charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1)
Unwrap cord and plug in the car power supply
interface. (See Fig. 1)
2)
Insert the battery pack into the charger, making
sure the battery pack is fully seated into the
charger. (See Fig. 2)
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
NOTICE: To extend the vehicles battery life,
it is recommended to only use the WA3764
charger while the vehicle is in operation.
CHARGING INDICATOR
This charger is designed to detect some problems
11~26V
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
18-20V
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
2A
original pack is defective and should be returned
to a service center or recycling service center. If the
50W
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
Li-ion
authorized service center.
Light
Red on
60min
120min
1.1 Ibs
Red flash
Green on
Green flash
BATTERY TEMPERATURE PROTECTION
This charger has a battery temperature protection
feature. When the charger detects a battery pack that
is too hot or cold (the light will be red and flash), it
automatically activates the protection circuit, and
suspends charging until the battery pack has reached
the correct temperature. The charging process will
then automatically begin (the light will be green and
flash). This feature ensures maximum battery life.
ON/ OFF
Status
Flash
Defective Battery
Battery Temperature
Protection
The temperature of
- - - - -
battery pack is less than
o
o
32
F(0
C) or more than
o
o
113
F(45
C).
Fully Charged
- - - - - -
Charging
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido