Monster PerfectView 400M Guía Del Usuario Y Garantía página 26

Routing Your TV's Power Cord and AV Cable
through the Cable Management System
1)
With the mount completely installed on the wall
and your TV properly secured to the mount,
fully extend the mount's Z-Fold
2)
Swing the mount completely to the left or right.
This enables you to slide off the cable channel covers
on all three swing arms.
3) Connect your TV's power cord to the TV (if TV uses
a detachable-type power cord).
4)
Slide the cable channel covers off the swing arms,
as shown to the right.
5)
Route your TV's power cord through the bottom
cable channel.
6) Route AV cable from your wall, set-top box, AV receiver,
or other source through the top channel and second
arm, as shown to the right and make connections to
your TV.
7)
Slide the cable channel covers back into place.
Snap the swing arm end caps back on, as shown.
22
swing arms.
™