Guardian Technologies AC5250 Instrucciones De Uso Y Cuidado página 4

INSTALLING/REMOVING COMbINATION FILTER
1. Turn off and unplug the unit.
2. Press the Lock & Release
Button and remove the
Rear Cover from the unit.
4. Before inserting new filter,
connect two filter pieces
together. Be sure the white,
pleated side of each filter piece
is facing the same direction,
then slide the plastic tabs
together and lock filter pieces
in place. Your new combination
filter is now ready to be inserted
into air purifier.
6. Reattach the Rear Cover of the unit and securely latch into place.
E-6
3. Remove the used
Combination Filter (Filter C)
and dispose of it in
the garbage.
5. Insert filter system into the unit.
Consult the arrow on the filter
for correct installation direction.
OPERATING INSTRUCTIONS
bEFORE OPERATING THE AIR PURIFIER:
1. Carefully remove your air purifier box and bag.
2. Remove rear cover, remove filter from bag, then return filter to unit.
3. Select a firm, level and flat location for the air purifier.
* For proper air flow, locate the unit at least 1 foot from any wall or furniture.
* Make sure none of the grills are blocked.
4. Plug the power cord into a 120V AC outlet.
IMPORTANT
:
When moving the air purifier, always lift unit by the carrying handle located on back.
OPERATING THE AIR PURIFIER:
1. Turn unit power ON.
2. Select fan speed MODE 1 - 5
(1 = lowest speed setting; 5 = highest speed setting)
3. Select UV-C ON or OFF using UV-C Power Button.
4. TIMER: If you prefer to run the purifier for a specific
number of hours, you can select between
1 and 8 hours on the display.
*Filter Replacement Indicator: The HEPA reset light on the control panel will
illuminate indicating that it is time to replace your filter. Replace the filter according
to directions (E-7) then insert pen tip into HEPA Reset area on control panel to restart
the system. Depending on usage, filter will last approximately 6 months. See
"Cleaning & Maintaining Filter (E-11) for proper care of filter.
E-7