Descargar Imprimir esta página

Laney LINEBACKER LR20 Manual Del Usario página 7

Publicidad

Nominal Supply Voltage
Mains Fuse
Power Consumption
Output Power Rating
Loudspeaker
Features
Footswitchable (optional)
Size (H*W*D)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encourage
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antena
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Unauthorized changes or modification to this system can void the user's authority to operate this equipment
This product conforms to the requirements of the following European Regulations, Directives & Rules:-
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal Household
waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the
In the interest of continued development, Laney reserves the right to amend product specification without prior notification.
~100V, ~115V, ~220V, ~230V, 50/60Hz Factory Option
(~100, ~110>~120V = T500mA L 250V)
50W
20W
Custom Designed 8"driver
2 Channels
2 x11 built in amp models
Contour & Presence EQ controls
Chorus,Flanger, Phaser, Tremolo, Delay & Reverb FX
Tuner Function
FS1 for Channel Change, FS2 for MOD FX / DEL FX ON/OFF
364*358*211
CE Mark (93/68/EEC), Low Voltage (72/23/EEC), EMC (2004/108/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
WEEE (Waste Electrical and Electronic Equipment) directive applicable in your country.
Unit Weight
8.5Kg
(~220V, ~230V, ~240V = T250mA L 250V)

Publicidad

loading